To set the interval for collecting traffic statistics on an interface, run the set flow-stat interval command in the interface view.Īlarm threshold for outbound and inbound bandwidth usages on the interface.
Interval for collecting traffic statistics on the interface. To change the interface status, run the shutdown command or the undo shutdown command in the interface view. Table 6-1 Description of the display default-parameter interface command output If the port mode or port copper mode configuration exists on a device, the configuration will not be deleted after the clear configuration this command is run. This command takes effect immediately in two-stage mode, and you do not need to run the commit command to commit the configuration. Running the clear configuration interface command on an interface is similar to running undo commands on the interface in batches.
If you enter Y, all configurations on the specified interface will be deleted. You can also run the clear configuration this command in the interface view to delete configurations on the interface.Īfter you run the clear configuration interface command, the system displays a message, asking you whether to delete the configurations on the specified interface.
To reduce the maintenance workload and simplify the deletion operation, run this command to perform one-click configuration deletion on the interface. If the interface has a large number of configurations, deleting these configurations one-by-one takes a long time and increases the maintenance workload. To configure an interface on a device for other uses, you need to delete original configurations from the interface one by one.
0 kommentar(er)
